Epson DS-570WII

Make sure you congure the administrator password before setting IPsec/IP ltering or IEEE802.1X.
Controlling Using Protocols
You can scan using a variety of pathways and protocols. Also, you can use network scanning from an unspecied
number of network computers.
You can lower unintended security risks by restricting scanning from specic pathways or by controlling the
available functions.
Controlling protocols
Congure the protocol settings supported by the scanner.
1.
Access Web
Cong
and then select the Network Security tab > Protocol.
2.
Congure each item.
3.
Click Next.
4.
Click OK.
e settings are applied to the scanner.
Related Information
& “Running Web
Cong
on a Web Browser” on page 26
Protocols you can Enable or Disable
Protocol Description
Bonjour Settings You can specify whether to use Bonjour. Bonjour is used to search for devices, scan, and so on.
SLP Settings You can enable or disable the SLP function. SLP is used for push scanning and network
searching in EpsonNet
Cong
.
WSD Settings You can enable or disable the WSD function. When this is enabled, you can add WSD devices,
and scan from the WSD port.
LLTD Settings You can enable or disable the LLTD function. When this is enabled, it is displayed on the
Windows network map.
LLMNR Settings You can enable or disable the LLMNR function. When this is enabled, you can use name
resolution without NetBIOS even if you cannot use DNS.
SNMPv1/v2c Settings You can specify whether or not to enable SNMPv1/v2c. This is used to set up devices,
monitoring, and so on.
SNMPv3 Settings You can specify whether or not to enable SNMPv3. This is used to set up encrypted devices,
monitoring, etc.
Administrator Information > Advanced Security Settings > Controlling Using Protocols
197