Epson DS-570WII - Page 222

If you cannot solve the problem, restore all network settings using the scanner's control panel. Connect the scanner
and computer, make the network settings again, and then make the settings for client
certication,
IPsec/IP
ltering, or IEEE802.1X.
The IP address of the scanner has been changed or cannot be used.
When the IP address registered to the local address on Group Policy has been changed or cannot be used, IPsec
communication cannot be performed.
Restore all network settings using the scanner's control panel.
If the DHCP is out of date, rebooting or the IPv6 address is out of date or has not been obtained, then the IP
address registered for the scanner's Web Cong (Network Security tab > IPsec/IP Filtering > Basic > Group
Policy > Local Address (Scanner)) may not be found.
Use a static IP address.
The IP address of the computer has been changed or cannot be used.
When the IP address registered to the remote address on Group Policy has been changed or cannot be used, IPsec
communication cannot be performed.
Restore all network settings using the scanner's control panel.
If the DHCP is out of date, rebooting or the IPv6 address is out of date or has not been obtained, then the IP
address registered for the scanner's Web Cong (Network Security tab > IPsec/IP Filtering > Basic > Group
Policy > Remote Address(Host)) may not be found.
Use a static IP address.
Cannot Connect After Conguring IPsec/IP Filtering
The set value may be incorrect.
Access the scanner according to its MAC address using EpsonNet Cong or Epson Device Admin from another
computer, such as administrator's. You can nd the MAC address on the label pasted on the scanner.
If you can access, make the IPsec/IP ltering settings using EpsonNet Cong or Epson Device Admin.
If you cannot access, restore all network settings using the scanner's control panel. Connect the scanner and
computer, make the network settings again, and then make the IPsec/IP ltering settings.
Cannot Access the Scanner after Conguring IEEE802.1X
The settings may be incorrect.
Restore all network settings using the scanner's control panel. Connect the scanner and computer, make the
network settings again, and then congure IEEE802.1X.
Administrator Information > Advanced Security Settings > Solving Problems for Advanced Security
222