3.
Load the envelopes into the input tray facing down making sure that the opened edge
(ap
side) of the
envelope is facing to the side. For envelopes with the opened edge (ap side) on the shorter side, you can load
the envelope with the opened edge
(ap
side) facing up.
Slide the envelopes into the ADF until they meet resistance.
c
Important:
Do not load envelopes with adhesives on them.
Note:
❏ Envelopes that are not opened by cutting sharply at the ap edge may not be scanned correctly.
❏ Envelopes that have not yet been sealed can be loaded with the ap open and facing up.
4.
Slide the edge guides to t the edge of the envelopes making sure there are no gaps between the envelopes and
the edge guides. Otherwise, the envelopes may be fed skewed.
Specications of Originals and Placing Originals
>
Placing Originals
>
Envelopes
60
To Next Page
Loading...
