Automatically Detect Input Signals and Change
the Projected Image (Source Search)
Press the [Source Search] button to project images from the port currently
receiving an image.
Because only images from ports receiving an image are projected, you can
quickly project the image you want.
Using the remote control Using the control panel
A
Computer
B
Video
C
HDMI (EB-1775W/EB-1770W/EB-1760W only)
D
USB Display
E
USB
F
LAN (EB-1775W/EB-1770W/EB-1760W only)
When two or more image sources are connected, press the [Source Search]
button until the target image is projected.
When your video equipment is connected, start playback before beginning
this operation.
a
The following screen is displayed when only the image that the
projector is currently displaying is available, or when no image signal
can be found. You can select the port where the equipment you want
to use is connected. If no operation is performed after about 10
seconds, the screen closes.
Example: EB-1775W/EB-1770W/EB-1760W
Projecting Images
27
To Next Page
Loading...
Need help?
General
