Info Menu (Display Only)
Lets you check the status of the image signals being projected and the status
of the projector. Items that can be displayed vary depending on the source
currently being projected. Depending on the model used, some input
sources are not supported.
s "Automatically Detect Input Signals and Change the Projected Image
(Source Search)" p.27
Submenu Function
Lamp Hours
You can display the cumulative lamp operating time
*
.
When it reaches the lamp warning time, the characters are
displayed in yellow.
Source
You can display the source name for the connected
equipment currently being projected.
Input Signal
You can display the content of Input Signal set in the
Signal menu according to the source.
Resolution
You can display the resolution.
Submenu Function
Video Signal
You can display the settings for Video Signal in the Signal
menu.
Refresh Rate
You can display the
refresh rate
g
.
Sync Info
You can display the image signal information.
This information may be needed if service is required.
Status
This is information about errors that have occurred on the
projector.
This information may be needed if service is required.
Serial Number
Displays the projector's serial number.
Event ID
(EB-1775W/
EB-1770W/
EB-1760W only)
Displays the application error log.
s "About Event ID (EB-1775W/EB-1770W/EB-1760W
Only)" p.116
*
The cumulative use time is displayed as "0H" for the first 10 hours. 10 hours
and above is displayed as "10H", "11H", and so on.
Reset Menu
List of Functions
84
To Next Page
Loading...
Need help?
General
