Epson EB-1775W - Switching to the Target Image by Remote Control; Projecting with USB Display; System Requirements

Switching to the Target Image by Remote Control
You can change directly to the target image by pressing the following
buttons on the remote control.
Remote control
A
Changes to images from the Computer port.
B
Each time the button is pressed, it cycles through the following images:
• Video port
• HDMI port (EB-1775W/EB-1770W/EB-1760W only)
C
Each time the button is pressed, it cycles through the following images:
• USB Display
• Images from the device connected to the USB (TypeA) port
D
Changes to the image projected with EasyMP Network Projection. When
projecting using the supplied or optional Quick Wireless Connection USB
Key, this button switches to that image. (EB-1775W/EB-1770W/EB-1760W
only)
Projecting with USB Display
You can use the supplied USB cable to connect the projector to a computer
to project images from the computer.
To start USB Display, set USB Type B to USB Display from the
Configuration menu.
s Extended - USB Type B p.74
System Requirements
For Windows
OS
Windows 2000 Service Pack 4
The following 32 bit operating systems:
Windows XP
Windows XP Service Pack 2 or later
Windows Vista
Windows Vista Service Pack 1 or later
Windows 7
CPU
Mobile Pentium III 1.2 GHz or faster
Recommended: Pentium M 1.6 GHz or faster
Amount of
Memory
256 MB or more
Recommended: 512 MB or more
Hard Disk
Free space
20 MB or more
Display
Resolution of no less than 640x480 and no higher than
1600x1200.
Display color in 16-bit color or greater
Projecting Images
28