Installation Guide
37
c
•
Connect the power cord last.
•
When connecting to the Audio1, Audio2, and Computer1 ports, we recommend connecting cables to
the ports in the following order: Audio1, Audio2, and then Computer1.
Adjusting the Projected Image
Follow the procedures below to adjust the projected image.
a
Adjusting the Projection Position (s p.37)
b
Fine-tuning the Focus (s p.42)
c
Calibrating the Pen (EB-585Wi/575Wi only) (s p.44)
Adjusting the Projection Position
•
Do not make adjustments using the projector's Keystone function. Doing so may result in a reduction in image quality.
•
When setting up multiple projectors using the batch setup function, perform this procedure before adjusting the
projected image.
s "Batch Setup Function" p.50
a
Press the [
t
] button on the remote control or the control panel to turn on the projector
Using the Remote Control Using the Control Panel
Caution
While projecting, do not put your face or hands near the air exhaust vent, and do not place objects
that may become warped or damaged by heat near the vent. Hot air from the air exhaust vent could
cause burns, warping, or accidents to occur.
To Next Page
Loading...
Need help?
General
