Projector Placement
25
Front Upside Down/Rear Upside Down
Front Upside Down/Rear Upside Down (Vertically)
Make sure you select the correct Projection option in the projector's
Extended menu according to the installation method being used.
a
• The default Projection setting is Front/Upside Down.
• You can change the Projection setting as follows by pressing down
the [A/V Mute] button on the remote control for about five seconds.
• Switch Front to/from Front/Upside Down
• Switch Rear to/from Rear/Upside Down
gg Related Links
• "Precautions on Installation" p.25
• "Projection Modes" p.51
Precautions on Installation
You can install the projector or mount it to the ceiling at any horizontal or
vertical angle. Note the following precautions when installing the projector at
an angle (EB‑700U).
Attention
• If the projector is installed at an angle, it should be installed by qualified
technicians using mounting hardware designed for use with this projector.
• Install the projector appropriately to prevent it from falling down.
• Use M4 screws (up to a depth of 12 mm) to fix the projector's ceiling mount
fixing points and the mounting hardware at four points.
To Next Page
Loading...
Need help?
General
