Adjusting the Brightness
75
You can adjust the brightness of your projector's light source.
a
This setting is available only when Multi-Projection is set to Off.
s Extended > Multi-Projection > Multi-Projection
a
Turn on the projector and switch to the image source you want to use.
b
Press the [Menu] button on the control panel or remote control.
c
Select the ECO menu and press [Enter].
d
Select Brightness Settings and press [Enter].
e
Select Light Source Mode and press [Enter].
f
Select one of the following options:
• Auto lets you set the brightness automatically (EB‑710Ui). Available
when you install the projector upside-down. The estimated life span
of the light source varies depending on usage conditions.
• Normal lets you set the brightness to the maximum level. This makes
the estimated life span of the light source approximately 20,000
hours.
• Quiet lets you set the brightness to 70% and reduces fan noise. This
makes the estimated life span of the light source approximately
20,000 hours.
• Extended lets you set the brightness to 70% and extends the life
expectancy of the light source. This makes the estimated life span of
the light source approximately 30,000 hours.
• Custom lets you to select a custom brightness level between 70 to
100%.
To Next Page
Loading...
Need help?
General
