Setup & Operation 1. Safety
14 G3 Rev.14
1.7 Warning Labels
The Manipulator has the following warning labels.
The warning labels are attached around the locations where specific dangers exist.
Be sure to comply with descriptions and warnings on the labels to operate and maintain
the Manipulator safely.
Do not tear, damage, or remove the warning labels. Use meticulous care when handling
those parts or units to which the following warning labels are attached as well as the
nearby areas.
Location
Before loosening the base mounting
screws, hold the arm and secure it
tightly with a band to prevent hands or
fingers from being caught in the
Manipulator.
B
Be careful to avoid collision.
C
Hazardous voltage exists while the
Manipulator is ON. To avoid electric
shock, do not touch any internal
electric parts.
D
You can catch your hand or fingers
between the shaft and cover when
bringing your hand close to moving
parts.
* Manipulators with bellows do not
have this label for no danger of your
hand or fingers being caught.
E
HOT
Be careful not to burn yourself.
F
Only authorized personnel should
perform sling work and operate a crane
and a forklift.
When these operations are performed
by unauthorized personnel, it is
extremely hazardous and may result in
serious bodily injury and/or severe
equipment damage to the robot
system.
G
Be careful of the hand falling or
rotating while the brake release switch
is being pressed.
To Next Page
Loading...
Need help?
General
