Epson L800 - Page 67

67
Run a Printer Check
A printer check will help you determine if the printer is operating properly.
Before running a printer check, make sure the output tray is in the paper position
1. Turn off the printer.
2. Disconnect the USB cable.
Ink level is low
Ink level may be low. You may continue printing. To
confirm the actual ink remaining,
visually check the ink levels in the
printer’s ink tanks. Epson
recommends that you continue using
the printer until the ink level reaches
the lower line so that the ink tank can
be refilled with the entire contents of
a new ink bottle.
Cover open
The printer cover is open. Close the printer cover.
Output tray error
The output tray is not in the correct
position.
Before turning on the printer, make
sure the output tray is set to the paper
(lower) position.
When printing on a CD or DVD, set
the output tray to the CD/DVD
position.
When printing on paper, set the
output tray to the paper position.
Flashing
alternately
Maintenance
The printer’s ink pads are at the end
of their service life.
Contact Epson support to replace ink
pads.
Unknown printer error
An unknown printer error has
occurred.
Turn off the printer. Open the printer
cover and remove any paper or other
obstruction from the paper path. Then
turn the printer back on. If the error
does not clear, contact Epson.