126
7. Safely remove the projector's removable drive from the computer, then disconnect the USB cable
from the projector.
The firmware update starts.
While the firmware is updating, the status indicators on the projector start flashing and the cooling fans
run at high speed (this is normal). After the update is complete, the projector enters standby mode. If
Direct Power On is enabled, the projector restarts automatically.
After the update is complete, check the Version setting in the Management > Information menu to
confirm that the firmware was updated successfully.
Parent topic: Updating the Firmware
Transporting the Projector
The projector contains precision parts, some of which are glass. Follow these guidelines to transport,
ship, or store the projector safely:
• Remove any equipment connected to the projector.
• Center the lens position using the Lens button.
Caution: If you transport the projector when the lens is not centered, the lens shift mechanism may be
damaged.
• Make sure the lens shutter is closed.
• When transporting the projector a long distance or as checked luggage, pack it in a firm box with
cushioning around it and mark the box "Fragile."
• When shipping the projector for repairs, place it in its original packing materials, if possible, or use
equivalent materials with cushioning around the projector. Mark the box "Fragile."
Note: Epson shall not be liable for any damages incurred during transportation.
Parent topic: Maintaining and Transporting the Projector
Related tasks
Turning Off the Projector
To Next Page
Loading...
Need help?
General
