Epson LS11000 - Monitoring and Controlling the Projector; Connecting to a Wired Network; Selecting Wired Network Settings

35
Monitoring and Controlling the Projector
Follow the instructions in these sections to monitor and control the projector over a network.
Connecting to a Wired Network
Selecting Wired Network Settings
Connecting to a Wired Network
To connect the projector to a wired local area network (LAN), use a 100Base-TX or 10Base-T network
cable. To ensure proper data transmission, use a Category 5 shielded cable or higher.
1. Connect one end of the network cable to your network hub, switch, or router.
2. Connect the other end of the cable to the projector's LAN port.
Parent topic: Monitoring and Controlling the Projector
Selecting Wired Network Settings
Before you can control the projector on your network, you must select the network settings for the
projector using its menu system.
Note: Make sure you already connected the projector to your wired network using the LAN port.
1. Turn on the projector.
2. Press the Menu button.