Troubleshooting 117
5
5
5
5
5
5
5
5
5
5
5
5
You can print the self test using either single sheets or continuous
paper. See “Printing on Continuous Paper” on page 17 or
“Printing on Single Sheets” on page 32 for paper-loading
instructions.
c
Caution:
For LX-300+II, you should use paper at least 210 mm (8.27
inches) wide to run the self test; otherwise, the print head prints
directly on the platen.
For LX-1170II, you should use paper at least 376 mm (14.8
inches) wide to run the self test; otherwise, the print head prints
directly on the platen.
Follow these steps to perform a self test:
1. When using continuous paper, make sure paper is loaded,
and the paper release lever is set to the correct position. Then
turn off the printer.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
2. To run the test, turn on the printer while holding down the
LF/FF button or Load/Eject button.
Self test is printed in Draft characters when the LF/FF button
is held, or in NLQ characters when the Load/Eject button is
held.
3. When using single-sheet paper, load paper in the printer.
After a few seconds, the printer loads the paper automatically
and begins printing the self test. A series of characters is
printed.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
