Paper Handling 37
2
2
2
2
2
2
2
2
2
2
2
2
❏ Load labels the same way as you would load ordinary
continuous paper. See “Printing with the pull tractor” on page
22 for loading instructions.
❏ Because labels are especially sensitive to temperature and
humidity, use them only under normal operating conditions.
❏ Do not leave labels loaded in the printer between jobs; they
curl around the platen and may jam when you resume
printing.
❏ To remove the labels from the printer, tear off the fresh supply
at the bottom of the printer; then press LF/FF to advance the
remaining labels out of the printer.
c
Caution:
Never feed labels backwards through the printer; they can easily
peel off the backing sheet and jam the printer. If a label does become
stuck in the printer, contact your dealer.
Envelopes
You can feed envelopes individually using the paper guide. Keep
the following tips in mind:
❏ Before loading an envelope, set the paper thickness lever to
the proper position. See “Adjusting the paper thickness lever”
on page 35.
❏ To load an envelope, follow the steps in “Loading single
sheets” on page 33. Insert the wide edge of the envelope into
the printer first, printable-side down. When you insert the
envelope between the paper guides, push it firmly and hold
it until it feeds into the printer.
❏ Use envelopes only under normal temperature and humidity
conditions.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
