Paper Handling 33
2
2
2
2
2
2
2
2
2
2
2
2
❏ The illustrations in this manual are from LX-300+II. LX-1170II is
wider than LX-300+II. However, the explanations are the same.
Loading single sheets
Follow these steps to load single sheets:
1. Make sure the printer is turned off. Also make sure that the
paper release lever is pushed back to the single-sheet position
and the paper guide is in the upright position, as shown
below.
2. Slide the left edge guide until it locks in place at the guide
mark. Next, adjust the right edge guide to match the width of
your paper.
To Next Page
Loading...
