94 Control Panel
International character set for Italic table
You can select among several international character sets for the
Italic character table. Each character set contains eight characters
that vary depending on the country or language, so you can
customize the Italic table to suit your printing needs.
Manual feed wait time
This sets the amount of wait time between the time paper is
inserted into the paper guide and when it is fed. If the paper feeds
before you can adjust its position to your satisfaction, you can
increase the wait time.
Buzzer (beeper)
The printer beeps when an error occurs. (See “Using the Error
Indicators” on page 97 for more information on printer errors.) If
you do not want the printer to beep when an error occurs, turn
this setting off.
Auto CR (carriage return)
This setting is available only in the IBM 2380 Plus (for
LX-300+II)/IBM 2381 Plus (for LX-1170II) emulation mode. When
auto carriage return is on, each line feed (LF) code or ESC J code
is accompanied by a carriage return code. This moves the print
position to the beginning of the next line.
IBM character table
This setting is available only in IBM 2380 Plus (for LX-300+II)/
IBM 2381 Plus (for LX-1170II) emulation mode. When you select
table1, hex codes 80H to 90H of the character tables are used for
the control codes. When you select table 2, hex codes 80H to 90H
are used for characters.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
