Epson Perfection4180 Photo - Page 50

EPSON Perfection4180 Photo Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 50
5. Disconnect the Inverter Cable Connector and Fluorescent Lamp Connector from the
TPU Inverter Board.
6. Remove the two screws (CBP, M3x6) that are securing the Inverter Board, and remove
the Inverter Board together with the Protective Sheet.
7. Open the Protective Sheet and remove the Inverter Board.
Figure 4-32. Removal of Connector Cables
Figure 4-33. Removal of TPU Inverter Board
When reinstalling the TPU Inverter Board, route the cables into the
five notches indicated by A, B and C.
B
C
A
B
A
C
Fluorescent Lamp Connector
Inverter Cable Connector
M3x6
Tightening torque 3.5±0.5kgfcm
Protective Sheet
Inverter Board