Presenting Through a Wireless Network 67
Setting Up Your Macintosh for Ad Hoc Mode
Your AirPort software is automatically configured to allow your
Macintosh to detect both computer-to-computer (Ad Hoc) and
Access Point networks.
Typically, you only need to select your projector’s ESSID from the
AirPort status menu on the Macintosh menu bar. If you’re having
problems detecting the projector, follow these steps:
1. From the Apple pull-down menu, select
System Preferences.
2. Double-click the
Network icon. You see the Network settings
window.
3. Make sure Location is set to
Automatic.
4. Select
Network Port Configurations in the Show pull-down
menu.
5. Under Port Configurations, select
AirPort.
6. Click
Apply Now. Then close the window.
note:
If you don’t need the other
network port
configurations, disable
them by deselecting their
checkboxes. If more than
one network port is
enabled, the projector
software warns you to
turn off AirPort when you
first connect the projector.
Disregard this message.
Select
Automatic
Select Network Port
Configurations
then select AirPort
To Next Page
Loading...
