Epson Stylus C62 - Page 141

EPSON Stylus C50/C60/C61/C62 Revision C
Maintenance Overview 133
Figure 6-4. Lubrication point 1
5
<Lubrication point>
• Upward teeth area of the Spur gear 60.
Then, rotate it 90 degrees to the backside
of the printer. Refer to Figure 6-9.
<Lubrication type>
•G-58
<Lubrication amount>
•
Φ
1mm x 20mm
• Use a syringe to apply it.
• Do not touch the lubrication
area.
[Note]
You need not to perform this
lubrication unless the this part is
established for the service part.
6
<Lubrication point>
• Center of the Pulley driven shaft (1 point)
• Around the hole of the Pulley driven (2
points) Refer to Figure 6-10.
<Lubrication type>
•G-58
<Lubrication amount>
• Pulley driven shaft :
Φ
1 mm x 1mm
• Pulley driven :
Φ
1 mm x 1mm for each
position
• Use a syringe to apply it.
7
<Lubrication point>
• Inner side of the Main frame.Refer to
Figure 6-11.
<Lubrication type>
•G-58
<Lubrication amount>
• 2mm (Smooth G-58 by using a brush
evenly)
• Use a brush to apply it.
• Do not touch the lubrication
area.
• Do not stain or drop it on other
part
[Note]
You need not to perform this
lubrication unless the this part is
established for the service part.
Table 6-2. Lubrication point
No. Lubrication type/point Remarks
8
<Lubrication point>
• Along the circle of the PF roller (Space
between PF roller bushing and plane
washer) Refer to Figure 6-12.
<Lubrication type>
•G-46
<Lubrication amount>
• Spread G-46 evenly by using the flux
dispenser.
• Use a flux dispenser to apply it.
• Do not touch the lubrication
area.
[Note]
1) You need not to perform this
lubrication unless the this part is
established for the service part.
2) This lubrication is adopt on the
Stylus C61/C62 only.
Table 6-2. Lubrication point
No. Lubrication type/point Remarks
G-58