Epson Stylus C62 - Page 154

EPSON Stylus C50/C60/C61/C62 Revision C
Appendix Connector Summary 146
*b : Manufacture and Description name show the following setting.
Name mode
Customer name
Table 7-16. EEPROM Address Map (continued)
10Off 10Off
Bit7 Bit6 Name mode
0 0 Ineffective
0 1 Apply to the Description and Manufacture
1 0 Apply to the Description
1 1 Reserved
Bit5 Bit4 Bit3 Bit2 Bit1 Bit0 Customer name
000000 Acer
0 0 0 0 0 1 Apple
000010Compaq
0 0 0 0 1 1 Dell
000100Machines
0 0 0 1 0 1 Fujitsu
000110Hewlett-Packard
0 0 0 1 1 1 IBM
001000Gateway
0 0 1 0 0 1 NEC
001010Panasonic
0 0 1 0 1 1 Sharp
001100Sony
0 0 1 1 0 1 Toshiba
001110PHILIPS
Bit3 Bit2 D4 mode Bit1 Bit0 D4 mode
Address Explanation Setting
QPIT
setting
Factory
setting
30H Interface selection 01H : Auto
02H : Parallel
08H : USB
Others : Auto
00H 00H
31H Interface time-out 0 to 255
(by second,
value of 0 means 10 seconds)
0AH 0AH
32H I/F Speed Bit7,6: Reserved
Bit5: Reserved
Bit4:
Bit3: ECP speed
Bit2:
Bit1: Compatibility speed
Bit0:
00H 00H
33H Bi-D Adjustment 1
for Multi Shot Bk
-36<=n<=+36(by 1/2880inch) 00H (*1)
34H Bi-D Adjustment 2
for 6pl VSD Bk
-36<=n<=+36 (by 1/2880inch) 00H (*1)
35H Bi-D Adjustment 3
for 4pl VSD Bk
-36<=n<=+36 (by 1/2880inch) 00H (*1)
36H Bi-D Adjustment for
Multi Shot (Cl)
-36<=n<=+36 (by 1/2880inch) 00H (*1)
37H Bi-D Adjustment for
6pl VSD (Cl)
-36<=n<=+36 (by 1/2880inch) 00H (*1)
38H Bi-D Adjustment for
4p lVSD (Cl)
-36<=n<=+36 (by 1/2880inch) 00H (*1)
39H 1stDot Position
Adjustment
-36<=n<=+36 (by 1/2880inch) 00H (*1)
3AH CL2 Counter KK 00H 03H