EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 123
4.2.7.2 PF Motor
1. Remove the Printer Mechanism. See section 4.2.1.5 on page 82.
2. Disconnect the PF Motor Connector Cable from Connector CN7 (black) on the
Main Board, and remove it from the Clamp on the Main Frame.
3. Remove the two C.C. 3x4 screws that secure the PF Motor.
4. Remove the PF Drive Belt from the PF Motor Pinion Gear, and remove the PF
Motor from the Printer Mechanism.
Figure 4-135. Removing the PF Motor
1
2
11) C.C. 3x4
(4±0.5 kgf.cm)
CN7
PF Motor
PF Drive Belt
PF Motor Connector Cable
Clamp
Pinion Gear
Face the slit of the PF Motor as shown in Figure 4-136.
Figure 4-136. Installing the PF Motor
Tighten the screws in the order shown in Figure 4-135.
A D J U S T M E N T
R E Q U I R E D
After replacing or removing the PF Motor, the following
adjustment must be performed.
1. PF Belt Tension Adjustment (p.132)
2. PF Roller Shaft Center Support Position Adjustment (p.132)
3. PF Adjustment (p.132)
4. PF Adjustment (Bottom Margin) (p.133)
Refer to Chapter 5 “Adjustment” for details on the adjustments.
Slit
To Next Page
Loading...
