Epson Stylus Photo 1390 - 6.1 Overview; 6.1.1 ROM Replacement; 6.1.2 Cleaning

EPSON Stylus Photo 1390/1400/1410 Revision B
MAINTENANCE Overview 149
6.1 Overview
This section provides information to maintain the printer in its optimum condition.
6.1.1 ROM Replacement
This printer may require the ROM to be replaced when the program is changed or
added. In such cases, use the special tool (ROM puller: 2035659 (#F749)) to replace
the ROM. The position of the ROM is shown in the figure below.
Figure 6-1. ROM Location
6.1.2 Cleaning
This printer has no mechanical components which require regular cleaning. Therefore,
when returning the printer to the user, check the following parts and perform
appropriate cleaning if stain is noticeable.
 Housing
Use a clean soft cloth moistened with water and wipe off any dirt. If the Housings
are stained with ink, use a cloth moistened with neutral detergent to wipe it off.
 Inside the printer
Use a vacuum cleaner to remove any paper dust.
C655 Main Board
ROM(IC6)
C A U T I O N
 Never use chemical solvents, such as thinner, benzine, and
acetone, to clean the exterior parts of the printer like the
housing. These chemicals may degrade or deteriorate the
quality of this product.
 Be careful not to damage any components when you clean
inside the printer.
 Do not scratch the surface of the PF Roller assembly. Use a soft
brush to wipe off dust.
 Use a soft cloth moistened with dilute alcohol to remove ink
stain.
 Do not make regular use of the supplied cleaning sheet for
normal use. It may damage the coated surface of the PF Roller.
It is okay if the adhesive surface of the cleaning sheet is set to
the ASF LD Roller side and used to clean the ASF LD Roller
surface.
 When using compressed air products; such as air duster, for
cleaning during repair and maintenance, the use of such
products containing flammable gas is prohibited.