Epson Stylus Photo 1390 - Sharp Metal Edges; Method for Making CSIC Board Removal Tool

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Overview 75
4.1.5 Sharp Metal Edges
Figure 4-1. Parts with Sharp Metal Edges
4.1.6 Method for making CSIC board removal tool
The CSIC board (refer to p94) can be easily removed by using a special tool. The
method for making the tool is described below.
1. Prepare a handle part of a clip, or a similar metal wire piece.
Figure 4-2. Method for making CSIC Board Removal Tool (1)
2. Bend the metal wire into dimensions described below.
Figure 4-3. Method for making CSIC Board Removal Tool (2)
C A U T I O N
During disassembly/reassembly of the Stylus Photo 1390/1400/1410,
extra care must be taken to avoid injury from sharp metal edges,
especially from the edges shown below.
Main Frame
Main Frame
Main Frame
Main Frame
Main Frame
Board Shield Plate
USB Connector of
PictBridge Unit*
*Stylus Photo1390 does not have this unit.
Handle part
Clip
7mm
25mm
50mm
Special Tool