EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 122
4.2.7 Removing the Motors
4.2.7.1 CR Motor
1. Remove the Upper Housing.
For Stylus Photo 1400/1410: See section 4.2.1.4 on page 80.
For Stylus Photo 1390: See section 4.3.1 on page 128.
2. Release the Carriage lock, and move the Carriage Unit to the center.
See section 4.2.1.3 on page 79.
3. Disconnect the CR Motor Connector Cable from the Relay Connector.
Figure 4-132. Removing the CR Motor Connector Cable
4. Push the Driven Pulley toward the center to loosen the CR Drive Belt, and remove
the CR Drive Belt from the CR Motor Pinion Gear.
5. Remove the two C.B.S. 3x4 screws that secure the CR Motor, and remove the CR
Motor from the Main Frame.
Figure 4-133. Removing the CR Motor
CR Motor
Relay Connector
CR Motor Connector
Cable
CR Drive Belt
Driven Pulley
CR Motor Pinion Gear
Face the Lot No. printed surface of the CR Motor as shown in
Figure 4-134.
Figure 4-134. Installing the CR Motor
Tighten the screws in the order shown in Figure 4-133.
A D J U S T M E N T
R E Q U I R E D
After replacing the CR Motor, the following adjustment must be
performed.
CR Motor Drive Dispersion (p.133)
Refer to Chapter 5 “Adjustment” for details on the adjustments.
2
1
10) C.B.S. 3x4
(4±0.5 kgf.cm)
Lot No. Printed Surface
To Next Page
Loading...
