EPSON Stylus Photo 1390/1400/1410 Revision B
TROUBLESHOOTING Overview 40
3.1 Overview
This chapter describes unit-level troubleshooting.
3.1.1 Troubleshooting according to Panel Messages
After checking the printer LED and STM3 error indications, you can grasp the fault location using the check list in this section. When you find the fault location, refer to Chapter 4
“Disassembly and Reassembly” and change the corresponding part and/or unit. The following table indicates the check point reference tables corresponding to the error states (LED
and STM3).
C H E C K
P O I N T
As the photos and illustrations used in this chapter are of Stylus
Photo 1400/1410, there may be some differences in the appearance
but the errors and remedies itself are not affected.
Table 3-1. Reference Tables of Error States
Error State Reference Table
Communication Error Refer to Table 3-2 "Troubleshooting of Communication Error" on page 41
Model Difference Refer to Table 3-2 "Troubleshooting of Communication Error" on page 41
Cover Open (Tray) Error Refer to Table 3-3 "Troubleshooting of Cover Error" on page 44
Paper Out Error Refer to Table 3-4 "Troubleshooting of Paper Out Error" on page 44
Paper Jam Error Refer to Table 3-5 "Troubleshooting of Paper Jam Error" on page 48
Paper Mismatch Error Refer to Table 3-6 "Troubleshooting of Paper Mismatch Error" on page 49
Ink Low Refer to Table 3-7 "Troubleshooting of Ink Low" on page 49
Ink End Error Refer to Table 3-8 "Troubleshooting of Ink End Error" on page 49
No Ink Cartridge/CSIC Error Refer to Table 3-9 "Troubleshooting of No Ink Cartridge/CSIC Error" on page 50
Maintenance Request Error Refer to Table 3-10 "Troubleshooting of Maintenance Request" on page 52
Fatal Error Refer to Table 3-11 "Troubleshooting of Fatal Error" on page 53
To Next Page
Loading...
