Epson Stylus Photo 1390 - Waste Ink Pad

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 84
4.2.2 Waste Ink Pad
1. Remove the Lower Housing. See section 4.2.1.5 on page 82.
2. Remove the C.B.P. 3x8 screw that secures the Waste Ink Tube.
3. Remove the 11 Waste Ink Pads from the Lower Housing.
Figure 4-21. Removing the Waste Ink Pads
4) C.B.P. 3x8
(6±1 kgf.cm)
Waste Ink Pads
 Route the Waste Ink Tube as shown below.
Figure 4-22. Positions of Waste Ink Tubes
 Referring to Figure 4-23, correctly install the Waste Ink Pads.
Figure 4-23. Installing the Waste Ink Pads
A D J U S T M E N T
R E Q U I R E D
After replacing or removing the Waste ink Pads, be sure to make
the following adjustments.
 Waste Ink Protection Counter Reset (p.134)
Refer to Chapter 5 “Adjustment” for details on the adjustment.
Waste Ink Tubes
1
2
1
2
3
4
Installation
Order
Installation
Order