Epson Stylus Photo 1390 - 4.3.2 Paper EJ Frame Assy

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Procedure Specific to Stylus Photo 1390 129
5. Disconnect the Panel FFC from connectors CN1 on the Switch Board.
Figure 4-148. Disconnecting the Panel FFC
6. Remove the Guide Pins from the two tabs shown in Figure 4-147, and remove the
Upper Housing upwards.
4.3.2 Paper EJ Frame Assy
1. Remove the Upper Housing. See section 4.3.1 on page 128.
2. Remove the Left Frame Support Plate. See Step 2 in Section 4.2.6.5 on page 98.
3. Put back the rotation position of the Right PG Cam.
4. Remove the four C.B.S. 3x6 screws that secure the Paper EJ Frame Assy.
Figure 4-149. Screws that Secure the Paper EJ Frame Assy
 Align the Guide Pins with the positioning holes of the Upper
Housing. See Figure 4-147.
 Tighten the screws in the order shown in Figure 4-147.
CN1
Panel FFC
Guide Pin
2
3
Tabs
2) C.B.S. 3x6
(8±1 kgf.cm)
4
1
Tabs
Paper EJ Frame Assy