Epson Stylus Photo 1390 - Page 130

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Procedure Specific to Stylus Photo 1390 130
5. Pull the Star Wheel Roller toward you, and remove the Paper EJ Frame Assy from
the Printer Mechanism.
Figure 4-150. Removing the Paper EJ Frame Assy
C A U T I O N
When performing the following procedure, take care not to scratch
the Star Wheel.
Star Wheel Roller
 Hook both rear ends of the Paper EJ Frame Assy onto the tabs
of the Main Frame.
Figure 4-151. Installing the Paper EJ Frame Assy
 Match the tabs with the five Positioning Holes.
See Figure 4-149.
 Tighten the screws in the order shown in Figure 4-149.
A D J U S T M E N T
R E Q U I R E D
After replacing or removing the Paper EJ Frame Assy, the
following adjustment must be performed.
1. PW Sensor Adjustment (p.133)
2. PF Adjustment (p.133)
3. PF Adjustment (Bottom Margin) (p.133)
Refer to Chapter 5 “Adjustment” for details on the adjustments.
Tabs