Epson Stylus Photo 1390 - Front Paper Guide Pad

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 85
4.2.3 Front Paper Guide Pad
1. Remove the Printer Mechanism. See section 4.2.1.5 on page 82.
2. Remove the Front Paper Guide Pads and Front Paper Guide Pad Protection from
the Front Paper Guide with tweezers.
Figure 4-24. Removing the Front Paper Guide Pads and
the Front Paper Guide Pad Protection
C A U T I O N
Make sure that the grease contained in the Front Paper Guide Pads
and the Front Paper Guide Pad Protection do not stick to other
parts.
Front Paper GuideFront Paper Guide Pads
Front Paper Guide Pad
Protection
After installing the Front Paper Guide Pads and Front Paper Guide
Pad Protection, lift the Printer Mechanism, and check the following
points.
1. Make sure that the tabs on the Pads are not cut midway.
2. Make sure that all tabs are in place on the Front Paper
Guide, and that they are facing down (toward the Waste Ink
Pads) without any folds.
3. Make sure that the turned edges of the tabs are protruding
completely from the Front Paper Guide.
Figure 4-25. Installing the Front Paper Guide Pad (1)
4. Make sure that the Pad is placed under a tab of the Front
Paper Guide.
Figure 4-26. Installing the Front Paper Guide Pad (2)
5. Make sure that all the tabs on the Pads are fitted into the
securing section under the Front Paper Guide.
Tabs
Tabs
OK
NG