Epson Stylus Photo 1390 - Page 140

EPSON Stylus Photo 1390/1400/1410 Revision B
ADJUSTMENT Adjustment 140
5.2.2.1 PG Adjustment Method
1. Place the printer on a level base.
2. Connect the Tester to the printer frame and Adjustment Gauge.
Figure 5-4. Connecting the Tester
C A U T I O N
 Before starting PG adjustment, completely wipe off drops of
ink around the Printhead. Remaining drops of ink will stick to
the continuity measurement portion of the Adjustment Gauge,
and generate continuity before the continuity measurement
portion makes contact with the metal frame around the
Printhead, interrupting accurate PG Adjustment.
 As the ink in the Printhead may stick fast and damage the
Printhead during PG Adjustment, make the continuity time
detected with a tester as short as possible. (Maximum 3
minutes)
C H E C K
P O I N T
As the photos used to explain these adjustments are of Stylus Photo
R1800, there may be some differences in the appearance but the
adjustments itself are not affected.
C A U T I O N
The printer must be placed on a level and warp-free base. Any tilt
or wrap on the base makes the adjustment improper.
Tester
Adjustment Gauge
Frame