Epson Stylus Photo 1390 - Page 145

EPSON Stylus Photo 1390/1400/1410 Revision B
ADJUSTMENT Adjustment 145
4. Loosen the screws that secure the Center Support Bushing Cam and the Center
Support Bush.
Figure 5-14. Center Support Bushing Cam and the Screw
5. Set the jig in place on the PF Roller Shaft as shown in the figure below.
 Left side: Inside of PF Roller left end (E-ring)
 Right side: Gap between PF Roller right end (Right Bushing 8) and left end
of Upper Paper Guide
 Center: Gap between the 2nd Upper Paper Guide and 3rd one from the
left
Figure 5-15. Setting the PF Roller Shaft Position Adjustment Jig
C A U T I O N
Check if any dirt is on the PF Roller Shaft. If there is, remove it
before performing the following procedure.
Center Support
Bushing Cam
Bottom of Rear Center