Epson Stylus Photo 1390 - Page 49

EPSON Stylus Photo 1390/1400/1410 Revision B
TROUBLESHOOTING Overview 49
Note *: Stylus Photo 1390 does not have the CD/DVD-related units.
Table 3-6. Troubleshooting of Paper Mismatch Error
Occurrence
Timing
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
At operation* When feeding a CD-R (Board
Paper), an error is displayed on
the LED and STM3.
Paper EJ Frame
Assy
(CD/DVD Tray
Base)
1. Check if the CD/DVD Tray Base is closed or not. 1. Open the CD/DVD Tray Base.
CD-R Sensor 1. Check that the Connector cable of the CD-R Sensor is securely
connected to the connectors of the CD-R Sensor and Panel
Board.
1. Connect the Connector cable of the CD-R
Sensor to the CD-R Sensor and Panel Board
Connectors.
2. Check the CD-R Sensor or Connector cable for damages. 2. Replace the CD-R Sensor with a new one.
Panel Board connector
Connector cable of
the CD-R Sensor
CD-R Sensor
Table 3-7. Troubleshooting of Ink Low
Occurrence
Timing
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
At operation or
during printing
A message is displayed on the
LED and STM3 during
printing.
Ink Cartridge 1. Look at the remaining ink indication of the STM3 to check the
amount of the ink remaining in the Ink Cartridge.
1. Prepare a new Ink Cartridge.
Table 3-8. Troubleshooting of Ink End Error
Occurrence
Timing
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
During printing After the Carriage has detected
the HP, an error is displayed on
the LED and STM3.
Ink Cartridge 1. Look at the remaining ink indication of the STM3 to check
whether the ink remains in the Ink Cartridge.
1. Replace the Ink Cartridge with a new one.