Epson Stylus Photo 1390 - Page 67

EPSON Stylus Photo 1390/1400/1410 Revision B
TROUBLESHOOTING Overview 67
The printout is
stained with ink.
The non-printed side or the
bottom of the printout is dirty
with ink.
Front Paper
Guide Pad
1. Check if the Front Paper Guide Pad is installed securely and
evenly in the setting position.
1. If the Ink pads are not securely installed,
reinstall the Front Paper Guide Pad correctly.
When the paper size in the sent
print data is larger than the size
of the fed paper, data is printed
on the Front Paper Guide,
extending off the paper.
PW sensor 1. Check that the PW Sensor FFC is connected. 1. Connect the PW Sensor FFC.
2. Check that the PW Sensor is not faulty. 2. Replace the PW Sensor with a new one.
Ink smudges appear on the blank
area of the printout.
Paper EJ Frame
Assy.
1. Check the Star Wheel Rollers for ink stain. 1. Clean the Star Wheel Rollers with a soft cloth.
Front Paper
Guide
1. Check the Front Paper Guide for ink stain. 1. Clean the Front Paper Guide with a soft cloth.
Table 3-12. Print Quality Troubles
Observed Faults Details of the Fault
Faulty Part/
Part Name
Check Point Remedy
Front Paper Guide Pad Front Paper Guide