Epson Stylus Photo 1390 - Page 81

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 81
PRINTER COVER
1. Remove the two C.B.P. 3x8 screws that secure the Left Printer Cover Holder, and
draw it out in the direction of the arrow.
Remove the Right Printer Cover Holder in the same way.
Figure 4-14. Removing the Printer Cover Holder
2. Lift the Upper Housing in the direction of the arrows, pull the Guide Pin on the
Upper Housing away from the cutout on the Printer Cover, and remove the Printer
Cover.
Figure 4-15. Removing the Printer Cover
4) C.B.P. 3x8
(6±1 kgf.cm)
Right Printer Cover Holder
Left Printer Cover Holder
Guide Pin on the Upper Housing
Cutout on the Printer Cover
Upper Housing
Printer Cover