296 Troubleshooting
Canceling Printing
If you encounter problems while printing, you may need to cancel
printing. To cancel printing, follow the instructions in the
appropriate section below.
Using the control panel buttons
Press the ) paper button while printing to cancel the printing of
a print job.
You may not be using the
correct interface cable.
If you are using the USB interface, use a
Revision 1.1 or 2.0 cable.
Some error may have
occurred.
Check the lights on the Control Panel to see
if lights other than power light are flashing
or on in red.
& See “Error indicators” on page 269
Your printer may have
broken.
Print the nozzle check pattern to see if the
printer is broken.
& See “Running a printer operation check”
on page 272
If the printer does not print, it may broken.
Contact your dealer.
Your application software
is not properly set up for
your printer.
Make sure that the printer is selected in your
application software.
Your computer system’s
memory is too small to
handle the volume of data
in your document.
Try reducing the image resolution of your
document in the application software, or
install more memory in your computer if
you can.
To Next Page
Loading...
