346
Paper Handling
Loading single sheets of paper
Follow the steps below to load paper into the printer.
1. Open the paper support, then slide out the paper support
extension.
2. Make sure the output tray is ejected, and the output tray
extension is slid out.
3. Position the left edge guide so that the distance between the
two edge guides is slightly wider than the width of your
paper.
4. Fan a stack of paper, then tap it on a flat surface to even the
edges.
5. Load the paper with the printable side up so it is against the
right edge guide, and slide it into the sheet feeder. Then slide
the left edge guide against the left edge of the paper.
To Next Page
Loading...
