359
Loading and removing roll paper
Loading the roll paper
With the roll paper holder attached to the printer, you can print
on roll paper, which is convenient for banner printing. When you
are printing on roll paper, keep the following in mind:
❏ Load the paper printable side up.
❏ Use flat, undamaged paper. If the paper is curled, flatten it
before loading to avoid paper feed problems.
❏ Always handle the paper by the edges.
❏ Provide ample space in front of the printer for the paper to
eject fully.
❏ Make sure the front printer cover is open and the output tray
is stored in the printer.
❏ Check that the end of the paper is cut cleanly, perpendicularly
to the length of the paper. If the paper is cut diagonally or
uncleanly, it may not feed smoothly or the printer may print
beyond the edge of the paper.
❏ Use Epson media to ensure high-quality results.
❏ Always check the ink levels before printing on roll paper, as
replacing ink cartridges while the roll paper is loaded can
smear the paper.
❏ We recommend replacing the roll paper with a new roll when
there is 20 cm remaining. Otherwise, print quality may be
compromised on the remaining portion.
Follow the procedure described below to install the roll paper
holders and load the roll paper.
To Next Page
Loading...
