Epson SureColor F6370 - Page 111

111
Error messages Solution
F/W Install Error
Firmware update failed.
Restart the printer.
Turn off the product, wait a few minutes, and turn it on again. Then reinstall
the firmware again using Epson LFP Remote Panel 2.
If this message persists, contact Epson for support.
Take-up Error
Check Auto Take-up
Reel Unit and restart
printer.
Turn off the product, wait a few minutes, and turn it on again. If this message
persists, contact Epson for support.
Reel Unit Error
Turn off the Auto switch
to cancel the error.
Paper has not been wound correctly on the auto take-up reel. Set the Auto
switch on the auto take-up reel to Off and perform the following operations:
When the leading edge of the paper has come off the take-up roll core
Tape the leading edge of the paper to the take-up roll core.
When an error is displayed during take-up and printing
Press the down arrow button to feed the paper, then use scissors or a
commercially available cutter to cut the paper after the final print out.
Remove the paper from the take-up reel. Install a new take-up roll core and
use tape to secure the leading edge of the paper to the core. Set the Auto
switch on the auto take-up reel to the Backward position and press the OK
button.
Reel Unit Error
Connect Auto Take-up
Reel Unit cable and
restart printer.
Reconnect the auto take-up reel cable to the product and turn the product off
and on again.
Reel Unit Disconnected
Auto Take-up Reel Unit
is disconnected. Do you
continue?
The auto take-up reel is not connected. Reconnect the auto take-up reel
cable to the product and select No to turn the product off. Wait a few minutes
and turn it on again. To continue printing without using the auto take-up reel,
select Yes.
Paper Cut Error
Remove uncut paper.
Press the OK button, pull out the paper, and cut the media using scissors or
a third-party cutting tool. Pull the edge of the paper straight out of the product
then press the OK button.