100
Set the paper feed location from the LCD screen before printing. Select > General Settings >
Printer Settings > Paper Source Settings > Cut Sheet/Poster Board Paper Slot, and select Front or
Back.
Load poster board in portrait orientation (short edge first), otherwise print quality may decline. You can
load poster board up to .06 inches (1.5 mm) thick.
Note: Remove any loaded paper, including roll paper, before you load cut sheet paper or poster board.
Make sure there is enough space at the back of the printer.
1. Select the paper information area on the LCD screen.
2. Select Poster Board > OK.
To Next Page
Loading...
