79
1. Turn off the Auto Cut setting in the printer driver or the control panel, depending on the situation:
• If you want to cut the paper manually, turn off the setting in the printer driver. Select Advanced >
Roll Paper Option > Auto Cut.
Note: The Auto Cut setting in the printer driver takes priority over the setting in the control panel.
The printer driver setting returns to automatic cutting when you close the application.
• If you are using a paper type that cannot be cut with the built-in cutter, turn off the setting in the
control panel. From the roll paper information area, select Advanced Media Setting > Auto Cut >
Off.
2. Print your document.
3. Select > Paper Setting > paper source > Feed/Cut Paper.
4. To move the paper into a cutting position, press and hold Forward or Backward until the cut
location reaches the cutting position labeled on the printer.
5. Cut the paper, depending on the situation:
• If the auto cut setting is turned off only in the printer driver, the paper is cut and the paper leading
edge returns to the print wait position.
• If the auto cut setting is turned off in the control panel, select Cut to manually cut the paper with
scissors or select Print Cutting Guideline to print a line on the paper to guide with manual
cutting.
Note: If the paper cannot be cut by the built-in cutter, select Forward until your print is clear of the
printer, then cut the print by hand.
Parent topic: Cutting Roll Paper
Printing Cutting Guidelines
When you disable the Auto Cut setting, you can print a cutting guideline between print jobs as a guide for
manual cutting.
1. Select > General Settings > Printer Settings > Paper Source Settings > Roll Paper Setup >
Cut Settings.
2. Turn off the Auto Cut setting.
3. Select Print Cutting Guideline > On to print cut lines on roll paper.
Note: Cut guidelines are not available when printing on cut sheets or poster board.
To Next Page
Loading...
