90
Cut Sheet Handling
You can load a variety of types and sizes of cut sheet paper in your product.
Loading Cut Sheets
Loading Poster Board
Parent topic: Media Handling
Loading Cut Sheets
You can feed cut sheets from the front or the back of the printer. In both cases, the paper is ejected from
the front after printing.
Set the paper feed location from the LCD screen before printing. Select > General Settings >
Printer Settings > Paper Source Settings > Cut Sheet/Poster Board Paper Slot, and select Front or
Back.
You can load most photo and fine art sheet papers up to .03 inches (0.8 mm) thick.
Note: Remove any loaded paper, including roll paper, before you load cut sheet paper or poster board.
Make sure there is enough space at the back of the printer.
1. Select the paper information area on the LCD screen.
2. Select Cut Sheet > OK.
To Next Page
Loading...
