110
Creating Custom Paper Settings
You can create and store up to 30 custom paper settings for use in printing on non-Epson paper or paper
that is not supported by the Epson printer driver.
1. Load the type of paper that you want to configure in the printer.
2. Select > General Settings > Printer Settings > Custom Paper Setting.
3. Select a number for the custom paper setting.
Note: You cannot change paper setting information registered using the printer driver or other
software using the LCD screen.
4. Select Change Reference Paper.
5. Select a paper preset that is similar to the paper that you loaded following these guidelines:
• Photo paper: Baryta
• Fine art paper: Fine Art Matte
• Canvas: Satin Canvas or Matte Canvas
• Plain paper: Plain Paper
• Glossy paper: Photo Paper
• Thick, non-glossy paper: Matte Paper
• Thin, soft, non-glossy paper: Plain Paper
• Canvas-like paper: Canvas
• Cotton paper with a rough surface: Fine Art Paper
• Special media such as film, cloth, poster board, or tracing paper: Others
6. Select Advanced Paper Settings and enter a value for the following settings:
• Paper Thickness
• Roll Core Diameter (roll paper only)
• Paper Feed Offset (leave at 0 unless you see horizontal banding)
Note: The Paper Feed Offset setting allows you to adjust the difference between the data size and
the print size. For example, if you are printing at a data size of 3.9 inches (100 mm) and a print
size of 4 inches (101 mm), the offset is 1.0%. Therefore, you would enter a value of -1.0%.
To Next Page
Loading...
