117
Adjusting the Paper Feed
Parent topic: Media Handling
Related concepts
Print Head Nozzle Check
Optimizing the Media Settings (Automatic Adjustment)
You can perform an automatic feed adjustment from the product control panel. Make sure the length of
the loaded media is at least 22 inches (558 mm) and the width is 15 inches (388 mm) or wider.
Note: You may not be able to perform automatic adjustment depending on the media you are using. If an
error occurs, or if you notice banding or graininess in the print results even after automatic adjustment,
perform Paper Feed Adjust and Ruled Line Alignment from the Print Adjustments menu.
1. From the home screen, select Paper Setting > paper source > Print Adjustments > Automatic
Adjustment.
2. Select Standard > Auto Adjustment > Start.
An adjustment pattern is printed. View the results and determine if a manual adjustment is
necessary.
Parent topic: Paper Feed Adjustment
Adjusting the Paper Feed
You can adjust the paper feed manually and perform a ruled line alignment from the product control
panel if you can still see banding after performing an automatic feed adjustment. Perform Paper Feed
Adjust and Ruled Line Alignment separately. In both cases, visually inspect the printed pattern and
enter the measurements to perform adjustments.
Make sure the length of the loaded media is at least 22 inches (558 mm) and the width is 15 inches (388
mm) or wider. When adjusting using commercially available paper, make sure you register the custom
paper in advance.
1. Select a paper type that matches the paper in the printer.
2. Select > Paper Setting > Print Adjustments > Paper Feed Adjust from the control panel.
3. Select the paper feed adjustment that best suits your needs and intended use.
4. If you select manual adjustment, follow the on-screen instructions to make adjustments.
Parent topic: Paper Feed Adjustment
To Next Page
Loading...
