Epson TM-C3500 Series - Page 20

20
*1: In some cases, missing dots and irregularity in ink shots may occur when printing ladder barcodes,
resulting in the ANSI grade being lowered to F and making barcodes unreadable. Apply an
innovative method such as printing HRI characters.
*2: Ink may penetrate the paper due to its characteristics, causing the bars of printed barcodes to
become thicker. In such cases, reduce the data in a bar by one pixel and increase the blank space
by one pixel (Adjust Bar Width).
*3: The recommended values for specified media types and barcodes are as follows.
For wristbands and Code 128: Five-dot module and ANSI grade D
For wristbands and Codabar: Four-dot module, minimum element ratio of 2.5, and ANSI grade C
Wristbands Speed Fence Yes 3 dot
2.7
4 dot
2.5
Ladder 6 dot
2.5
*3
-
*3
-
Quality
(Mode1)
Fence 3 dot
2.7
4 dot
2.5
Ladder 6 dot
2.5
*3
-
*3
-
Q NOTE
If an odd number value is set for the Module, changing the Media Type
and Print Quality causes the resolution to change, resulting in a change in
the size of the printed barcode.
General settings
Print
direction
*1
Font settings of barcodes/2-dimensional symbols
Media type
Print
quality
Adjust
Bar
Width
*2
Upper line: Minimum module (dot)
Lower line: Minimum element ratio
ANSI
grade D or
higher
ANSI
grade C or
higher
ANSI
grade B or
higher