57
c IMPORTANT
• Paper with holes or cutouts cannot be used.
• Auto cutting on the perforated lines will generate scraps of paper that may
cause problems. Also, auto cutting ahead of the perforated line may cause
problems when feeding paper. Therefore, perform auto cutting 0.5 to
1 mm behind the perforated line.
• Set the black mark position 2 mm or more from the perforated line.
• For the black mark position of the die-cut label paper, match the label
leading edge to the black mark leading edge.
• Use uncut perforations on both sides of the paper.
• Both types, paper without waste part and paper without the left and right
waste parts, can be used.
• Providing a black mark on both sides enables the paper to be used even
when inserted from either side.
Q Note
Depending on the shape of die-cut labels, the labels may peel off their
backing paper inside the printer. When you want to use die-cut labels that do
not meet the specifications, contact qualified service personnel for advice.
Mark width
Mark center position
Mark length
Mark interval
Paper width center
Perforation
position
2 mm or
more
Fanfold
paper
Paper width
center
Paper feed
direction
Normal black
mark position
Black mark
position
when
inserted in
reverse
direction
Backing paper
Label
To Next Page
Loading...
Need help?
General
