72
Memory Switch Setting Mode
In the memory switch setting mode, you can set the following memory switches.
Starting the memory switch setting mode
Follow the steps below to run this mode.
1
Close the roll paper cover.
2
While pressing the Feed button, turn on the printer. (Keep pressing the
Feed button until the printer starts printing.)
The printer starts printing current status of the printer.
When the printer finishes printing the printer status, the following message is printed and
the Paper LED flashes. (The printer is now in the self-test wait mode.):
“Select Modes by pressing Feed button.
Continue SELF-TEST: Less than 1 second
Mode Selection: 1 second or more”
3
Press the Feed button. (Keep pressing the Feed button until the printer
starts printing.)
The printer starts printing instructions.
4
Press the Feed button three times.
•Receive buffer capacity•BUSY condition
•Processing when data receive error • Auto line feed
•USB power-saving function • Release condition of receive buffer BUSY
• Roll paper width•Print density
•Print speed • Character code table default
•International character default •Number of columns
•Autocutting after closing cover • Font replacement
•Optio
nal buzzer • Communication condition of USB interface
•Communication condition of serial interface
With the Ethernet interface, before printing starts, it takes 15 seconds if the IP address is
fixed and 20 seconds if the IP address is obtained with the automatic setting. (It may take
longer, depending on the response time from the host.)
To Next Page
Loading...
