1. Make sure the toolbar display is set to Full.
2. If you are connected to multiple projectors, click the button on the toolbar and select the
projector you want to control.
3. Click the button on the toolbar.
4. Perform one of the following operations.
• Switch to a computer source: Click the button.
• Switch to a video source: Click the button.
Parent topic: Controlling the Projected Display
Finishing Projecting Images
You can finish projecting images by using the toolbar.
Click the button to disconnect. The computer and the projector are disconnected and the LAN
standby screen is projected. The search and connect screen is displayed in EasyMP Network Projection
software.
Parent topic: Connecting to the Projector and Projecting Images
44
To Next Page
Loading...
Need help?
General
