2. Slide the edge guides.
3. Load paper at the center of the rear paper feed with the printable side facing up.
c
Important:
❏ Do not load more than the maximum number of sheets specied for the paper. For plain paper, do not load
above the line just under the triangle symbol inside the edge guide.
❏ Load paper short edge rst. However, when you have set the long edge as the width of the user dened size,
load paper long edge rst.
Pre-punched paper
Note:
❏ Load a single sheet of dened size plain paper with binding holes at the le or right.
❏ Adjust the print position of your le to avoid printing over the holes.
❏ Automatic 2-sided printing is not available for pre-punched paper.
User's Guide
Preparing the Printer
29
To Next Page
Loading...
