Epson WorkForce WF-7830 Series - Network Specifications

Network Specications
Wi-Fi Specications
Standards
IEEE802.11b/g/n
*1
Frequency Range 2.4 GHz
Coordination Modes
Infrastructure, Wi-Fi Direct (Simple AP)
*2*3
Wireless Securities
*4
WEP (64/128bit), WPA2-PSK (AES)
*5
, WPA3-SAE (AES)
*1 IEEE802.11n is only available for the HT20.
*2 Not supported for IEEE 802.11b.
*3 Simple AP mode is compatible with a Wi-Fi connection (infrastructure) or an Ethernet connection.
*4 Wi-Fi Direct supports WPA2-PSK (AES) only.
*5 Complies with WPA2 standards with support for WPA/WPA2 Personal.
Ethernet Specications
Standards
IEEE802.3i (10BASE-T)
*1
IEEE802.3u (100BASE-TX)
IEEE802.3az (Energy Ecient Ethernet)
*2
Communication Mode Auto, 10Mbps Full duplex, 10Mbps Half duplex, 100Mbps
Full duplex, 100Mbps Half duplex
Connector RJ-45
*1 Use a category 5e or higher STP (Shielded twisted pair) cable to prevent risk of radio interference.
*2 The connected device should comply with IEEE802.3az standards.
Product Information > Product Specications > Network Specications
289